International & Wholesale Site
Northern America Sales Site
 


IDE Adapter
 
   Slim CD Rom IDE Adapter:
  • Adapt from the standard 40 pins IDE port to a slim CD Rom connecter.
  • On the IDE side, it has a small 4 pins power connecter and 2 audio (4-pin & 3-pin) ports to fit with wide range of CD audio output signal.
  • This adapter is use for all chassis that configured with slim optical drive.
   

2.5Ħħ Slim Hard Drive IDE Adapter:
  • Convert the standard 40-pin IDE connecter to a 44-pin 2.5Ħħ slim hard drive port.
  • 5 volts DC power input through a large 4-pin connecter and nearly 4Ħħ long wire.
This adapter is used for slim IDE hard drive only; each drive requires one adapter.
   

3 Ports Slim IDE Cable:

  • Convert a standard 40-pin IDE connecter to two 44-pin 2.5Ħħ slim hard drive ports with 4Ħħ long small 4-pin DC connecter. Total length of the cable is 13Ħħ and around 5Ħħ long between two 44-pin connecters.
  • This cable is designed to fit into the limit space when 2.5Ħħ drives are sitting side-by-side and hard to add an adapter for each drive. Soft cut cable between two 44-pin connecters will allow easy arrangement for each drive.
  • Chose this cable instead of Slim Hard Drive IDE Adapter when you configure ITS-0812 or 0815 with 2 or more 2.5Ħħ IDE drives.
 
 

CF2-800 IDE Compact Flash Card Reader:

  • General Purpose: Compatible with all IDE motherboard
  • Bootable Device: Works like an IDE disk, no special drivers needed
  • Vertical 40-pin socket for IDE cable, Standard 4-pin Power Connector
  • Jumper configuration: Master/ Slave
  • Low power (less than 0.5W), No acoustic noise
  • Fast startup time, no spin up, fast read access time
  • Not sensitive on shock and vibration
  • Size: 3Ħħ W, 2-1/2Ħħ D, 1/2Ħħ H
This card is used on all Half-2U and ITX-1U series chassis.
   

CF2-504 IDE Compact Flash Card Reader:

  • General Purpose: Compatible with all IDE motherboard
  • Bootable Device: Works like an IDE disk, no special drivers needed
  • Horizontal 40-pin Connecter and mini 2-pin Power Connector
  • Jumper configuration: Master/ Slave
  • Low power (less than 0.5W), No acoustic noise
  • Fast start up time, no spin up, fast read access time
  • Not sensitive on shock and vibration
  • Size: 2-3/8Ħħ W, 2-1/8Ħħ D, 1/4" H
This card is used on all Half-1U series case.
 
 
Copyright 2005 iDOTpc International, Inc. All rights reserved